B95W
Maintenance
06_Wartung und Pflege_en.fm - V1.0 - 1.8.17
169 / 306
6
20
Draining the
hydraulic oil
Place the loading equipment flat on the ground.
Completely retract the bucket cylinder and the dipperstick cylinder and
completely lower the boom, articulated to the left, onto the ground.
Place the dozer blade on the ground.
Bring the hydraulic oil up to operating temperature.
All hydraulic cylinders must be retracted.
Shut down the engine.
Unscrew the ventilation filter (3).
Place suitable oil collecting vessels under the drain opening.
Attach an oil draining hose (it is in the tool bag) to the oil change valve on the
underside of the tank.
J The oil drains away.
Flush and clean the hydraulic oil tank if necessary. To do this, remove the
return filter (1).
Drain off oil into a clean vessel.
Remove the oil drain hose and screw the protective cap on the oil change valve.
Topping up
hydraulic oil
Remove the cover from the return filter (1).
Fill up with new hydraulic oil until the right level has been reached on the sight
glass.
Fit the cover to the return filter (1).
Screw in the ventilation filter (3).
Check the filter and drain plug for leaks.
To Next Page
Loading...
