B95W
Operation
07_Bedienung_en.fm - V1.0 - 1.8.17
223 / 306
7
26
Switch on the working hydraulics using the keypad.
Switch off the travel range switch for high gear using the keypad.
Put the selection lever for the direction of travel (4) into neutral.
Switch on driving with rocker.
Increase the engine speed with the manual throttle (5) as required.
You can move the machine out of neutral by operating the foot rocker (1).
J The foot rocker (1) automatically returns to neutral position.
Gear shift control
Select the required setting I or II on the gear shift control switch.
J The control light on the display shows the selected setting.
Operate the foot brake until the machine comes to a standstill.
J If the control light on the display turns red, the selected gear setting cannot
be used.
Accelerate slightly until the control light shows the selected gear setting.
Automatic idle (optional)
When the auto-idling system is activated(See chapter 5.3.4 “Display”.), the
motor switches to idle speed after five seconds unless the driver operates one
of the control levers.
Advantages:
• Lower fuel consumption
• Lower noise level
• Increased engine lifespan
When one of the operating levers is used again, the engine speed increases to
the preselected setting.
To Next Page
Loading...
