YASKAWA A1000 HHP - Page 297

No.
(Addr.
Hex)
Name Description Values Page
T1-11
(70B)
Motor Iron Loss
V/f
OLV/PM
V/f w PG
AOLV/PM
OLV
CLV/PM
CLVV/f V/f w PG
Sets the iron loss for determining the Energy Saving coefficient.
The value is set to E2-10 (motor iron loss) set when the power is cycled. If
T1-02 is changed, a default value appropriate for the motor capacity that was
entered will appear.
Default: 14 W
<5>
Min.: 0
Max.: 65535
170
<1> The availability of certain Auto-Tuning methods depends on the control mode selected for the drive.
<2> Default setting is determined by parameter A1-02, Control Method Setting.
<3> Default setting is dependent on parameter o2-04, Drive Model Selection.
<4> Values shown are specific to 400 V class drives. Multiply the value by 1.4375 for 575 V class drives. Multiply the value by 1.725 for 690 V class
drives.
<5> Default setting value differs depending on the motor code value and motor parameter settings.
A.14 T: Motor Tuning
YASKAWA ELECTRIC SIEP YEAHHP 01B YASKAWA AC Drive – A1000 HHP Programming Manual
297
A
Parameter List