YASKAWA SGD7W - Page 336

Revision History-2
December 2015 <4> 0 Preface Addition: Information on SGMMV Servomotors
Chapters 1
and 11
Addition: Information on SERVOPACKs with a single-phase, 100-VAC power supply
input
Chapter 2 Addition: Information on SGMMV Servomotors
2.3.2, 3.4.2,
4.4.2, 4.5.3,
5.4.2, 6.4.2,
6.5.3, 7.4.1,
7.4.2, 7.5.1,
7.5.2
Revision: Battery Case pin numbers in connection specifications
8.1, 8.2.1,
8.2.3, 10.1.1
Addition: Information on SmartSCALE Linear Encoder from Magnescale Co., Ltd. and
LC115 Linear Encoder from Dr. JOHANNES HEIDENHAIN GmbH
11.8.6 Addition: Information on allowable frequency for regenerative operation for SGMMV Ser-
vomotors
Revision: Information on allowable frequency for regenerative operation for SGM7D Ser-
vomotors
September 2015 <3> 0 Front cover Revision: Format
Preface Partly revised.
All chapters Revision: Molex Japan Co., Ltd. changed to Molex Incorporated.
Chapter 6 Addition: Descriptions of SGM7D and SGMCV-D Servomotors
8.5.3 Revision: Description of wiring specifications
11.2 Addition: System requirements for SigmaWin+ version 7
Back cover Revision: Address and format
March 2015 <2> 0 All chapters Partly revised.
Chapters 2, 3,
4, 5, and 6
Revision: Information on Relay Encoder Cables
2.6, 3.6, 4.6,
5.6, 6.6, and
chapter 8
Revision: Sumitomo 3M Ltd. changed to 3M Japan Limited.
3.2 Revision: Information on SGM7A Servomotor Main Circuit Cables
4.4.2 Addition: Information on Encoder Cables for Incremental Encoders SGM7P-08 and
SGM7P-15 on Servomotors
5.2 Addition: Information on SGM7G-30 Servomotor
Chapter 7 and
9.1
Revision: Information on Linear Encoders from Mitutoyo Corporation
8.1, 8.2, 8.13,
8.14, 8.15,
and 9.2
Newly added.
August 2014 <1> 0 All chapters Corrected mistakes and made changes to some parts.
Preface,
10.8.6,
Chapter 11
Deletion: Information on SigmaJunmaSize+
Chapter 3 Addition: Information on SGM7A-40, -50, and -70
Chapter 4 Newly added.
Chapter 5 Addition: Information on SGM7G-30, -44, -55, -75, -1A, and -1E
10.1.2 Addition: Power supply specifications for using a DC power supply
10.4 Addition: Information on crimp terminals and insulating sleeves
10.8.5 Addition: Information on Regenerative Resistor Units
10.9 Addition: Information on inrush current suppression devices
May 2014 – – – First edition
Date of
Publication
Rev.
No.
Web
Rev.
No.
Section Revised Contents