YASKAWA U1000 Series - Page 107

3.9 Control Circuit Wiring
Electrical Installation
3
YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual 107
Connect control wires as shown in Figure 3.41 to Figure 3.44.
Figure 3.42
Figure 3.41 Terminal Board Wiring Guide (CIMR-UA/UD/UT)
Figure 3.43
Figure 3.42 Terminal Board Wiring Guide (CIMR-UB)
Figure 3.44
Figure 3.43 Terminal Board Location Inside the Drive (CIMR-UB)
Use the space above TB2 to wire TB4 through TB6 as illustrated in Figure 3.44.
Figure 3.45
Figure 3.44 Terminal Board Location Inside the Drive
A – Loosen screw to insert wire.
Wire in the following order:
TB4, TB5, TB6
C – Avoid fraying wire strands when stripping
insulation from wire. Strip length 5.5 mm.
B – Single wire or stranded wire D – Blade depth of 0.4 mm or less
Blade width of 2.5 mm or less
A – Loosen screw to insert wire. C – Avoid fraying wire strands when stripping
insulation from wire. Strip length 5.5 mm.
B – Single wire or stranded wire D – Blade depth of 0.4 mm or less
Blade width of 2.5 mm or less
A
B
TB6 TB5 TB4
C
D
Preparing wire
terminal ends
A
B
C
D
Preparing wire
terminal ends
SIEP_C710636_02B_1_0.book 107 ページ ２０１５年１１月２５日 水曜日 午後４時５６分