YASKAWA U1000 Series - Page 352

6.3 Drive Alarms, Faults, and Errors
352 YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual
■ Operation Errors
Table 6.12 Operation Error Displays
oS Overspeed YES 371
ov Control Circuit Overvoltage YES 371
PASS MEMOBUS/Modbus Comm. Test Mode Complete No output 371
PGo PG Disconnect (for Control Mode with PG) YES 371
PGoH PG Hardware Fault (when using PG-X3) YES 371
rUn Motor Switch during Run YES 371
SE MEMOBUS/Modbus Communication Test Mode Error YES 371
SrC Phase Order Detection Fault
YES 371
UL3 Undertorque Detection 1 YES 372
UL4 Undertorque Detection 2 YES 372
UL5 Mechanical Weakening Detection 2 YES 364
Uv Control Circuit Undervoltage YES 372
<1> Output when H2- = 2F.
Digital Operator Display
Name Page
Digital Operator Display
Name Page
LED Operator LCD Operator LED Operator LCD Operator
oPE01 Unit Capacity Setting Fault 373 oPE10 V/f Data Setting Error 374
oPE02 Parameter Range Setting Error 373 oPE11 Carrier Frequency Setting Error 374
oPE03 Multi-Function Input Setting Error 373 oPE13 Pulse Monitor Selection Error 374
oPE04 Terminal Board Mismatch Error 374
oPE15
Torque Control Setting Error 375
oPE05
Run Command/Frequency Reference
Source Selection Error
374 oPE16 Energy Saving Constants Error 375
oPE06 Control Method Selection Error 374 oPE18 Online Tuning Parameter Setting Error 375
oPE07
Multi-Function Analog Input Selection
Error
374
oPE20
PG-F3 Setting Error 375
oPE08 Parameter Selection Error 374
oPE30
Incorrect Input Voltage Adjustment 375
oPE09 PID Control Selection Fault 374 –– – –
Digital Operator Display
Name
Minor Fault Output
(H2- = 10)
Page
LED Operator LCD Operator
SIEP_C710636_02B_1_0.book 352 ページ ２０１５年１１月２５日 水曜日 午後４時５６分