1 Spot Welding Application Using a Motor Gun
1.11 Tip Dressing Instruction (SVDRESMOV Instruction)
1-94
1.11 Tip Dressing Instruction (SVDRESMOV Instruction)
As well as the clearance move instruction (SVSPOTMOV Instruction), all
the following operations become available only by this instruction after
teaching this instruction at a dressing position.
1. Moving to a position short before the dressing position
(moving to the clearance position)
2. Moving to a dressing position
3. Dressing operation
4. Moving to a position just behind the dressing position
(moving to the clearance position)
The clearance position mentioned above means the position where the
gun is opened over the dressing position by the clearance distance
specified by the tip dress condition file.
1.11.1 Operation Flow
The following shows the operation flow chart for the tip dressing
instruction teaching.
End
Select a teaching type
Set the following teaching type
-Teaching type 1: Lower-tip teaching
-Teaching type 2: Upper-tip teaching
-Teaching type 3: Gun-close teaching
Set the following conditions:
-Pressure condition
-Clearance condition
-Dresser condition
Set the following teaching data
-Teaching position (teaching)
-Moving speed
-Tip dress condition file No.
Set a clearance file
Teach a dressing point
Start
To Next Page
Loading...
