YASKAWA YRC1000 - Spot Supervision Window Setting

1 Spot Welding Application Using a Motor Gun
1.12 Tip Wear Detection and Wear Compensation (Motor Gun)
1-116
1.12.3 Spot Supervision Window Setting
Shows the tip wear amount, etc.
Also, the wear amount detection relevant settings can be performed.
 Spot supervision window
1. GUN NO.
Shows the gun No.
Select the No. by pressing [PAGE].
2. WELD COUNT
(CURRENT, TOLERANCE, SETTING(OUT#))
The numbers that the welding instruction (SVSPOT, SVSPOTMOV) is
performed is indicated to {CURRENT} as the present value.
Also, the universal output signal specified at {SETTING (OUT#)} is
turned ON when a value in {CURRENT} has exceeded a value in {TOL-
ERANCE}.
3. RESET COUNT
The value at {WELD COUNT (CURRENT)} can be cleared when the
signal specified to {RESET COUNT} is turned ON.
4. WEAR (M) (CURRENT, TOLERANCE, SETTING(OUT#))
Present wear amount at the movable side tip is indicated.
The value is updated when the wear detection is finished.
Also, the universal output signal specified at {SETTING (OUT#)} is
turned ON when the value in {CURRENT} has exceeded the value in
{TOLERANCE}.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
126 of 198