YASKAWA YRC1000 - Before Teaching; Manual Spot; Manual Dry Spot; Manual Press

1 Spot Welding Application Using a Motor Gun
1.5 Before Teaching
1-55
1.5 Before Teaching
Before using the motor gun, confirm the following operation instructions.
1.5.1 Manual Spot
For manual spot, perform the following operations.
1. Press [0/MANUAL SPOT] of the [Numeric Key].
2. Press [INTERLOCK] + [./SPOT].
– Spot welding is started and finished after the specified time.
Manual spot is executed while these keys are held down when the
MANUAL PRESS window is displayed.
Manual spot operates under the conditions that are set in the MANUAL
PRESS window.
1.5.2 Manual Dry Spot
For manual dry spot, perform the following operations.
1. Press [0/MANUAL SPOT] of the [Numeric Key].
2. Press [INTERLOCK] + [2/GUN CLOSE].
– Dry spot is started and finished after the specified time.
Manual dry spot operates under the conditions that are set in the
MANUAL PRESS window.
1.5.3 Manual Press
For manual press, perform the following operations.
1. Press [0/MANUAL SPOT] of the [Numeric Key].
2. Press [INTERLOCK] + [8/PRESSURE].
– Pressurizing is started and is kept till the next releasing operation is
started.
3. Press [INTERLOCK] + [9/RELEASE].
– Pressurizing is released and the gun is opened.
Manual press operates under the conditions that are set in the MANUAL
PRESS window.
SUPPLE-
MENT
Refer to chapter 1.9 Manual Pressure for the condition set-
tings.
SUPPLE-
MENT
Refer to chapter 1.9 Manual Pressure for the condition set-
tings.
SUPPLE-
MENT
Refer to chapter 1.9 Manual Pressure for the condition set-
tings.
65 of 198