1 Spot Welding Application Using a Motor Gun
1.12 Tip Wear Detection and Wear Compensation (Motor Gun)
1-126
1.12.7 Wear Amount Loading
Detected wear amount can be loaded in a job.
The wear amount is stored in the system D variable ($D). Use GETS
instruction and load the wear amount.
<Example>
GETS D000 $D030
The wear amount of Gun 1 (movable side) is stored in D000.
(Unit: μm)
$D30 Gun 1 movable side (upper) wear amount
$D31 Gun 1 fixed side (lower) wear amount
$D32 Gun 2 movable side (upper) wear amount
$D33 Gun 2 fixed side (lower) wear amount
$D34 Gun 3 movable side (upper) wear amount
$D35 Gun 3 fixed side (lower) wear amount
$D36 Gun 4 movable side (upper) wear amount
$D37 Gun 4 fixed side (lower) wear amount
$D38 Gun 5 movable side (upper) wear amount
$D39 Gun 5 fixed side (lower) wear amount
$D40 Gun 6 movable side (upper) wear amount
$D41 Gun 6 fixed side (lower) wear amount
$D42 Gun 7 movable side (upper) wear amount
$D43 Gun 7 fixed side (lower) wear amount
$D44 Gun 8 movable side (upper) wear amount
$D45 Gun 8 fixed side (lower) wear amount
$D46 Gun 9 movable side (upper) wear amount
$D47 Gun 9 fixed side (lower) wear amount
$D48 Gun 10 movable side (upper) wear amount
$D49 Gun 10 fixed side (lower) wear amount
$D50 Gun 11 movable side (upper) wear amount
$D51 Gun 11 fixed side (lower) wear amount
$D52 Gun 12 movable side (upper) wear amount
$D53 Gun 12 fixed side (lower) wear amount
To Next Page
Loading...
