2-23
IM 701310-01E
Explanation of Functions
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
App
Index
Displaying Signal Labels â–ºFor the procedure, see section 8.6
A label of up to eight characters can be assigned to each signal and displayed.
Snapshot and Snap Clear â–ºFor the procedure, see section 8.7
By using the snapshot function, you can temporarily hold the waveform (snapshot
waveform) that would be cleared when the screen is updated on the screen. The
snapshot waveform is displayed in white, allowing for easy comparison against the
updated waveform. The snapshot waveform can be printed as screen image data,
but cannot be used for cursor measurement, automated measurement of waveform
parameters, zoom, and computation functions.
Snap Clear
Press the SHIFT key, then press the SNAP SHOT key, to clear the snapshot waveform.
Translucent Display â–ºFor the procedure, see section 8.8â–ºFor the procedure, see section 8.8
Configuration dialog boxes are displayed translucently, so the contents underneath it can
be seen.
Scale Value Display â–ºFor the procedure, see section 5.12
The upper and lower limits (scale values) of the vertical and horizontal axes of each
waveform can be displayed.
2.6 Display
To Next Page
Loading...
Need help?
General
