YOKOGAWA PT500 - 2. Change the Min. rudder angle for alarm detection of the variation angle; 3. Change the Max. rudder angle for alarm detection of the variation angle

19-2
SM80B22M02E
1. Change the item.
（１）Press the ENTER
ENTERENTER
ENTER key after displayed "
Option Set 1… " on the data display.
Data display becomes setting mode of Servo loop failure alarm.
（２）Change the setting mode by using the △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- Key
①⇔②⇔③⇔④⇔⑤⇔⑥⇔⑦⇔⑧⇔⑨⇔⑩⇔①
①
⑥
②
⑦
③
⑧
④
⑨
⑤
⑩
Press ENTER
ENTERENTER
ENTER key to select the setting item.
2．Change the Min. rudder angle for alarm detection of the variation angle
Set the Min. rudder angle for alarm detection of the variation angle
（１）Press the ENTER
ENTERENTER
ENTER key after displayed "
Min.Angle= # #ˆ " on the data display.
Data display become under setting mode.
Setting range: from 2 to 10
(Initial value is set 5 degrees)
（２）Press △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- key to alter the Min. rudder angle for alarm detection of the variation
angle.
Press ENTE
ENTEENTE
ENTER
RR
R key to set the Min. rudder angle..
３．Change the Max. rudder angle for alarm detection of the variation angle
( For normal rudder angle:P/S Max.rudder order from 35 to 45degrees.)
（１）Press the ENTER
ENTERENTER
ENTER key after displayed "
Max.AngleN= # #ˆ " on the data display.
Data display become under setting mode.
Setting range: from 70 to 90
(Initial value is set 70 degrees)
（２）Press △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- key to alter the Max. rudder angle for alarm detection of the variation
Servo Loop Err.
Min.Angle< ##ˆ
Servo Loop Err.
Max.AngleN< ##ˆ
Servo Loop Err.
…
Max.TimeSW= ###s
Servo Loop Err.
…
<EXIT>
Servo Loop Err.
…
Min.Angle= # #ˆ
Servo Loop Err.
…
Min.TimeS= ##s
Servo Loop Err.
…
Max.AngleN= # #ˆ
Servo Loop Err.
…
Max.TimePW= ##s
Servo Loop Err.
…
Max.AngleW= ###ˆ
Servo Loop Err.
…
Max.Time PW= ###s
Servo Loop Err.
…
Max.TimeSN= ##s
Servo Loop Err.
…
Min.TimeP= ##s