Z3 Technology ZCube-21 - Page 50

ZCube-21 User Guide
DOC-USR-0253-01
______________________________________________________________________________________
Z3 Technology, LLC ♦ 100 N 8
th
ST, STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702
50
Check with network administrator.
Ethernet Speed*
Auto, Auto-100, 10Mbps,
1000Mbps
Sets the speed of the ethernet port.
Ethernet
Duplex*
Auto, Full, Half
Sets the duplex of the Ethernet port.
Device Setup
Auto Start
Checked
Unchecked
Check this box to set the system to automatically
start encoding upon powering on.
Advanced
Settings
Checked
Unchecked
Check this box for advanced encode settings to
appear on the channel tab.
Single Input
(Low Latency)
Checked
Unchecked
Check this box to enable single input mode which
enables lower latency encodes and allows slice
mode on channel 1. See DOC-USR-0169-0x for
more details (reboot required).
Display Setup
Resolution
AUTO
NTSC
PAL
Selects the desired resolution for Composite pass-
through output.
Set Display
Button
Click once the desired selection is made in the
Resolution dropdown menu to make real time
changes.
Device Management
Set Device Name
Button
Sets a custom name for the camera to appear in
the user interface.
New device
Name
Text box to enter desired device name.
Set Password
Button
Sets a password to limit access to the user
interface.
New password
Text box to enter new password.
Password again
Text box to re-enter new password.
Must match previous field.