Z3 Technology ZCube-21 - Zfinder

ZCube-21 User Guide
DOC-USR-0253-01
______________________________________________________________________________________
Z3 Technology, LLC ♦ 100 N 8
th
ST, STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702
62
Save Button
Click to save preset value to the selected
configuration.
Stop All Button
Stop all current encode channels. Encode must
be stopped in order for settings to be altered.
Start All Button
Start all encode channels.
System Status
OK
9.8 ZFinder
Buttons
Description
Refresh
Rescans the network for Z3 Technology products
Edit Device
Allows for manual edits to encoder settings:
Name: Name visible in ZFinder and top right corner of user interface (useful
when multiple units are on the same network)
IP Address
Subnet Mask
Gateway
Open Device
Opens the HTTP-based graphical user interface (GUI)
Flash LEDs
Causes status LED on the selected ZCube-21 to flash red approximately 30 times.
This is helpful when physically locating one of multiple devices on the same
network.
Update
Update device software via ZFinder protocol