Zapi DUALACE2 NEW GENERATION User Manual

Page 90/169 AFNZPxxx – DUALACE2 NEW GENERATION – User Manual
8.2.6 Special Adjustment
 Note: SPECIAL ADJUST. must only be accessed by skilled people. To change
settings in this group of settings, a special procedure is needed. Ask for this
procedure directly to a Zapi technician. In SPECIAL ADJUST. there are
factory-adjusted parameters that should be changed by expert technicians only.
SPECIAL ADJUSTMENTS
Parameter
Allowable range
Description
M ADJUSTMENT #01
(Read Only)
(A)
First gain of the first traction-motor current-sensing
amplifier.
NOTE: only Zapi technicians can change this value through
a special procedure.
M ADJUSTMENT #02
(Read Only)
(A)
Second gain of the first traction-motor current-sensing
amplifier.
NOTE: only Zapi technicians can change this value through
a special procedure.
S ADJUSTMENT #01
(Read Only)
(A)
First gain of the second traction-motor current-sensing
amplifier.
NOTE: only Zapi technicians can change this value through
a special procedure.
S ADJUSTMENT #02
(Read Only)
(A)
Second gain of the second traction-motor current-sensing
amplifier.
NOTE: only Zapi technicians can change this value through
a special procedure.
DIS.CUR.FALLBACK
(A)
OFF ÷ ON
This parameter disables or enables current reduction
(applied after one minute of traction).
ON = Current reduction is disabled.
OFF = Current reduction is enabled.
SET CURRENT
(Read Only)
(A)
(Factory adjusted). This is maximum current that the
inverter can provide to the motor.
M SET TEMPERAT.
(A)
0°C ÷ 255°C
(steps of 1°C)
This parameter calibrates the master controller-temperature
reading.
S SET TEMPERAT.
(A)
0°C ÷ 255°C
(steps of 1°C)
This parameter calibrates the slave controller-temperature
reading.
HW BATTERY RANGE
(Read Only)
(A)
0 ÷ 3
(steps of 1)
This parameter defines the battery voltage range.
NOTE: only Zapi technicians can change this value.

Zapi DUALACE2 NEW GENERATION Specifications

General

Brand	Zapi
Model	DUALACE2 NEW GENERATION
Category	Controller
Language	English