Zebra DS8178

Standard Parameter Defaults A - 3
User Preferences
Set Default Parameter N/A N/A Restore Defaults 5-5
Parameter Bar Code Scanning 236 ECh Enable 5-6
Beep After Good Decode 56 38h Enable 5-6
Direct Decode Indicator 859 F2h 5Bh Disable 5-7
Beeper Volume 140 8Ch High 5-8
Beeper Tone 145 91h Medium 5-9
Beeper Duration 628 F1h 74h Medium 5-10
Suppress Power Up Beeps 721 F1h D1h Do Not Suppress 5-10
Decode Pager Motor 613 F1h 65h Enable 5-11
Decode Pager Motor Duration 626 F1h 72h 150 msec 5-11
Night Mode Trigger (DS8178-HC
Only)
1215 F8h 04h BFh Disable 5-13
Night Mode Toggle (DS8178-HC
Only)
N/A N/A N/A 5-13
Lamp Mode Control 1711 F8h 06h AFh Disable 5-14
Lamp Mode Timeout 1712 F8h 06h B0h 5 Minutes 5-15
Low Power Mode 128 80h Enable 5-16
Time Delay to Low Power Mode 146 92h 5 sec 5-17
Timeout to Low Power Mode from
Auto Aim
729 F1h D9h 15 sec 5-19
Hand-Held Trigger Mode 138 8Ah Level 5-20
Hands-Free Mode 630 F1h 76h Enable 5-21
Hand-Held Decode Aiming Pattern 306 F0h 32h Enable 5-22
Hands-Free (Presentation) Decode
Aiming Pattern
590 F1h 4Eh Disable Hands-Free Decode
Aiming Pattern
5-23
Picklist Mode 402 F0h 92h Disabled Always 5-24
FIPS Mode 736 F1h E0h Disable 5-25
Continuous Bar Code Read 649 F1h 89h Disable 5-25
Unique Bar Code Reporting 723 F1h D3h Enable 5-26
Decode Session Timeout 136 88h 9.9 sec 5-26
Table A-1 Parameter Defaults (Continued)
Parameter
Parameter
Number
SSI Number Default
Page
Number