EasyManuals Logo

Zebra Z4Mplus User Manual

Zebra Z4Mplus
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #95 background imageLoading...
Page #95 background image
Configuration
Configuration and Calibration Sequence
Z4Mplus and Z6Mplus User Guide 65
PRINT WIDTH Press SELECT to make change.
Setting Print Width: Press PLUS (+) to increase the value,
press MINUS () to decrease the value. To change the unit
of measurement, press MINUS () until the unit of
measurement is active, then press PLUS (+) to toggle to a
different unit of measure (inches, mm, or dots).
Default; Range: The default and range of acceptable values
may vary depending on what printer you have. See Printing
Specifications on page 115 for further information about the
ranges available for your model.
Press SELECT to accept the change.
Print width determines the printable area across the width of
the label.
MAXIMUM LENGTH Press SELECT to make change.
Setting Maximum Length: Press PLUS (+) to increase the
value, press
MINUS () to decrease the value. Default is 39 in. (991
mm) for non-continuous material.
Press SELECT to accept the change.
Always set the value to at least 1 in. (25.4 mm) longer than
the longest label to be used in the printer.
LIST FONTS Press SELECT to select.
List Fonts: Press PLUS (+) to print a label listing all of the
available fonts.
This selection is used to print a label that lists all of the fonts
currently available in the printer, including standard printer
fonts plus any optional fonts. Fonts may be stored in RAM,
FLASH memory, font EPROMs, or font cards.
LIST BAR CODES Press SELECT to select.
List Bar Codes: Press PLUS (+) to print a label listing all
of the available bar codes.
This selection is used to print a label that lists all of the bar
codes currently available in the printer.
Display Shows Action/Explanation

Table of Contents

Other manuals for Zebra Z4Mplus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra Z4Mplus and is the answer not in the manual?

Zebra Z4Mplus Specifications

General IconGeneral
Print MethodThermal transfer or direct thermal
Resolution203 dpi
Max Print Width4.09 inches
Max Print Length39 inches
Max Print Speed10 inches per second
Memory4 MB Flash, 8 MB DRAM
InterfaceParallel, Serial
Media SensorsReflective and transmissive
Media Width0.79 inches to 4.5 inches
Media Length0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width2 inches to 4.33 inches
Power Requirements100-240 VAC, 50/60 Hz
Operating Temperature40°F to 105°F
Storage Temperature-40 to 140°F (-40 to 60°C)
Humidity20 to 85% non-condensing

Related product manuals