Zebra ZXP 1 Series User Manual

5: Replacement Procedures
Procedures
P1061942-001 Zebra ZXP Series 1 Card Printer Service Manual 159
Step 4. Set the Belt Tensioning Tool in place. Note that the arrows indicate the alignment
guide posts.
Step 5. Ensure that the tension arm is positioned under the belt (circled above).
Step 6. With a TORX T10 driver, tighten the two motor collar screws (7.0.in-lb).
Step 7. Rotate the Belt Tensioning Tool 180 degrees.

Zebra ZXP 1 Series Specifications

General

Resolution	300 dpi
Connectivity	USB 2.0
Power Requirements	100-240 VAC, 50-60 Hz
Print Technology	Dye sublimation
Card Capacity	100 cards (input hopper)
Card Size	CR-80 ISO 7810
Dimensions	368 mm (D)
Memory	32 MB
Operating Temperature	15°C to 30°C
Operating Humidity	20% to 65% non-condensing
Card Thickness	0.3mm - 1.06mm