ADJUSTMENT AND TESTS [AT DOCK]
Page 43
H) Store the value that has been set by following Section 6.1.6, page 24.
PWM (Duty Cycle) Voltage (VDC) Current (mA)
10)Replace Jumper 6 on Auxiliary Board
to its original position.
10)Reconnect the positive (+) throttle
signal wire from the governor
11)Reconnect the Throttle Wire Harness
to the Throttle Pigtail at the Processor.
Table 2: Throttle Maximum Output Adjustments
1 2 3
To Next Page
Loading...