Zte ZXR10 2920 - Table 90 Set Lacp Aggregator Delete Command; Table 91 Set Lacp Aggregator Mode Command; Table 92 Set Lacp Port Mode Command

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
88 Confidential and Proprietary Information of ZTE CORPORATION
Result: This adds a specified port to the aggregation group.
3. To delete a specified port to the aggregation group, use
command set lacp aggregator <trunkid> delete port
<portlist> in global configuration mode. This is shown in
Table 90.
TABLE 90 SET LACP AGGREGATOR DELETE COMMAND
Format Mode Function
set lacp
aggregator
<trunkid>
delete port
<portlist>
Global
config
This deletes a specified port to the
aggregation group
Result: This deletes a specified port to the aggregation
group.
4. To set aggregation mode of the aggregation group, use
command set lacp aggregator <trunkid> mode
{dynamic|static|mixed} in global configuration mode.
This is shown in
Table 91.
TABLE 91 SET LACP AGGREGATOR MODE COMMAND
Format Mode
Function
set lacp aggregator
<trunkid> mode
{dynamic|static|mixed}
Global
config
This sets aggregation
mode of the aggregation
group
Result: This sets aggregation mode of the aggregation
group.
5. To set the mode used by the port to participate in the
aggregation, use command set lacp port <portlist> mode
{active|passive} in global configuration mode. This is
shown in
Table 92.
TABLE 92 SET LACP PORT MODE COMMAND
Format Mode Function
set lacp port
<portlist> mode
{active|passive}
Global
config
This sets the mode used by the
port to participate in the
aggregation
Result: This sets the mode used by the port to participate in
the aggregation.
6. To configure the timeout information of the port
participating in the aggregation, use command set lacp
port <portlist> timeout {long|short} in global
configuration mode. This is shown in
Table 93.