Zte ZXR10 2920 - Table 208 Set Qos Policer Parameters Command; Table 209 Set Qos Policer Parameters Command

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
136 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 208 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set bandwidth
feport <portlist>
ingress session
<0-3> packet-
type
{unknowmulticast
| broadcast |
unicast |
multicast | MGMT
| ARP | tcp-
control | tcp-data
| udp | non-
tcpudp} {enable |
disable}
global config
This configures the
ingress session
packet-type
Result: This configures the ingress session packet-type of
flux monitor.
10. To configure the ingress session queue-priority of the flux
monitor, use command set bandwidth feport <portlist>
ingress session <0-3> packet-type {unknowmulticast |
broadcast | unicast | multicast | MGMT | ARP | tcp-
control | tcp-data | udp | non-tcpudp} {enable |
disable}in global configuration mode. This is shown in
Table 203.
TABLE 209 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set bandwidth
feport <portlist>
ingress session
<0-3> queue-
priority
<queuelist>
{enable |
disable }
global config
This configures the
ingress session
queue-priority
Result: This configures the ingress session queue-priority of
flux monitor.
11. To configure the ingress session mgmt-no-ratelimit of the
flux monitor, use command set bandwidth feport
<portlist> ingress session <0-3> mgmt-no-ratelimit
{enable | disable}in global configuration mode. This is
shown in
Table 203.