Zte ZXR10 2920 - Table 399 Set Ztp Command; Table 400 Set Ztp Port Command; Table 401 Set Ztp Trunk Command

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
246 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 399 SET ZTP COMMAND
Format Mode Function
set ztp
{enable|disable}
group config This enable/disable
the system ZTP
function
Result: This enable/disable the system ZTP function.
Note: By default, system ZTP function is enabled. When
system ZTP function is disabled, contents of switch topology
information table are cleared, and ZTP packets processing is
suspended.
2. To enable/disable port ZTP function, use command set
ztp port <portlist> {enable|disable} in group config mode.
This is shown in
Table 400.
TABLE 400 SET ZTP PORT COMMAND
Format Mode Function
set ztp port
<portlist>
{enable|disable}
group config This enable/disable
port ZTP function
Result: This enable/disable port ZTP function.
3. To enable/disable trunk ZTP function, use command set
ztp trunk <trunklist> {enable|disable} in group config
mode. This is shown in
Table 401.
TABLE 401 SET ZTP TRUNK COMMAND
Format Mode Function
set ztp trunk
<trunklist>
{enable|disable}
group config This enable/disable
trunk ZTP function
Result: This enable/disable trunk ZTP function.
Important! By default, ZTP function of all ports/trunks is
enabled. If ZTP function of a port/trunk is disabled, ZTP
packets processing of port/trunk is suspended.
Note: A port/trunk can collect and send ZTP information
normally only when both ZTP function of the port/trunk and
system ZTP function are enabled.
4. To configure ZTP parameters use the following commands
in group config mode as shown in
Table 402.