Zte ZXR10 2920 - Configuring QoS

Chapter 7 Service Configuration
Confidential and Proprietary Information of ZTE CORPORATION 119
TABLE 173 SET STP PORT PACKETTYPE COMMAND
Format Mode Function
set stp port <portlist>
packettype
{IEEE|CISCO|HUAWEI|
HAMMER|extend}}
Global
config
This sets port packet
type of the instance
Result: This sets port packet type of the instance.
28. To check STP port protocol type, use command set stp
port <portlist> pcheck in global configuration mode. This
is shown in
Table 174.
TABLE 174 SET STP PORT PCHECK COMMAND
Format Mode Function
set stp port
<portlist> pcheck
Global
config
This checks STP port
protocol type
Result: This checks STP port protocol type.
29. To set BPDU guard, use command set stp port
<portlist> bpdu-guard{enable|disable} in global
configuration mode. This is shown in
Table 175.
TABLE 175 SET STP PORT BPDU-GUARD COMMAND
Format Mode Function
set stp port <portlist>
bpdu-
guard{enable|disable}
Global
config
This sets BPDU guard
Result: This sets BPDU guard.
30. To set STP BPDU guard interval, use command set stp
bpdu_interval <10-65535> in global configuration mode.
This is shown in
Table 176.
TABLE 176 SET STP BPDU INTERVAL COMMAND
Format Mode Function
set stp
bpdu_interval <10-
65535>
Global
config
This sets STP BPDU guard
interval
Result: This sets STP BPDU guard interval.
31. To enable/disable STP relay, use command set stp
relay {enable|disable} in global configuration mode.
This is shown in
Table 177.