Zte ZXR10 2920 - Table 266 Dot1 X Quiet Period Command; Table 267 Dot1 X Quiet Period Command; Table 268 Dot1 X Supplicant Timeout Command

Chapter 8 Access Service
Confidential and Proprietary Information of ZTE CORPORATION 167
TABLE 266 DOT1X QUIET PERIOD COMMAND
Format Mode Function
dot1x quiet-
period <0-65535>
nas config This sets interval
between first
authentication
failure of
authentication
system and next
authentication
request
Result: This sets interval between first authentication failure
of authentication system and next authentication request.
2. To set time that authentication system needs to wait
before it can resend EAPOL data packet because it does not
receive the response from the client, use command dot1x
tx-period <1-65535> in nas config mode. This is shown
in
Table 267.
TABLE 267 DOT1X QUIET PERIOD COMMAND
Format Mode Function
dot1x quiet-
period <0-65535>
nas config This set time that
authentication
system needs to
wait before it can
resend EAPOL data
packet
Result: This set time that authentication system needs to
wait before it can resend EAPOL data packet.
3. To set timeout time for authentication system to receive
data packets from authentication client system, use
command dot1x supplicant-timeout <1-65535> in nas
config mode. This is shown in
Table 268.
TABLE 268 DOT1X SUPPLICANT TIMEOUT COMMAND
Format Mode Function
dot1x supplicant-
timeout <1-
65535>
nas config This set timeout
time for
authentication
system to receive
data packets from
authentication client
system
Result: This set timeout time for authentication system to
receive data packets from authentication client system.
4. To set timeout time for authentication system to receive
data packets from authentication server, use command
dot1x server-timeout <1-65535> in nas config mode.
This is shown in
Table 269.