ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
166 Confidential and Proprietary Information of ZTE CORPORATION
few packet interactions to determine whether the
subscriber is still on line.
f Abnormal off-line detection mechanism is implemented in
this way: Device takes the initiative to send a detection
request periodically to the client. EAPOL/EAP RepId
packet defined in the 802. 1x protocol is used as
request packet. When EAPOL/EAP RepId response is
received from client, it means that subscriber is still on
line. Otherwise, the subscriber is off line.
9. To set authentication mode of the port, use command
aaa-control port <portlist> protocol {pap|chap|eap} in
nas config mode. This is shown in
Table 265.
TABLE 265 AAA CONTROL PROTOCOL COMMAND
Format Mode Function
aaa-control port
<portlist> protocol
{pap|chap|eap}
nas config This sets
authentication
mode for the port
Result: This sets authentication mode for port.
Note: During the subscriber access authentication, there
are three subscriber identity authentication methods
between the authentication server and the authentication
system: PAP, CHAP, and EAP. The default one is EAP.
E
ND OF STEPS
802. 1x on ZXR10 2920/2928/2952 has been configured.
Configuring Protocol Parameters of
802. 1x
This topic describes the configuration of protocol parameters or
802. 1x on ZXR10 2920/2928/2952.
For the configuration of protocol parameters, perform the
following steps.
1. To set interval between first authentication failure of
authentication system and next authentication request, use
command dot1x quiet-period <0-65535> in nas config
mode. This is shown in
Table 266.
Result
Purpose
Steps
To Next Page
Loading...
