Zte ZXR10 2920 - Table 344 Set Vbas Cascade Port Command; Table 345 Show Vbas Command

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
206 Confidential and Proprietary Information of ZTE CORPORATION
Note: By default port is no trusted.
3. To enable/disable cascade port VBAS function, use
command set vbas cascade-port <portlist>
{enable|disable} in global configuration mode. This is
shown in
Table 344.
TABLE 344 SET VBAS CASCADE PORT COMMAND
Format Mode Function
set vbas cascade-
port <portlist>
{enable|disable}
global config This enable/disable
cascade port VBAS
function
Result: This enable/disable cascade port VBAS function.
4. To display VBAS configuration, use command show
vbas in global configuration mode. This is shown in
Table
345.
TABLE 345 SHOW VBAS COMMAND
Format Mode Function
show vbas global config This displays VBAS
configuration
Result: This displays VBAS configuration.
E
ND OF STEPS
VBAS has been configured.
This example describes how to trust port of switch A is port 1,
cascade port is port 2, and trust port of switch B is port 1. This
is shown in
Figure 35.
Configuration of Switch A
zte(cfg)#set vbas enable
zte(cfg)#set vbas trust-port 1 enable
zte(cfg)#set vbas cascade-port 2 enable
Configuration of Switch B
zte(cfg)#set vbas enable
zte(cfg)#set vbas trust-port 1 enable
Show Configuration of Switch A
zte(cfg)#show vbas
vbas enable
trust port :1
cascade port :2
Result
Example