Zte ZXR10 2920 - Command Show; Table 181 Set Stp Trunk Packettype Command; Table 182 Show Stp Command; Table 183 Show Stp Instance Command

Chapter 7 Service Configuration
Confidential and Proprietary Information of ZTE CORPORATION 121
TABLE 181 SET STP TRUNK PACKETTYPE COMMAND
Format Mode Function
set stp trunk < trunkid
> packettype
{IEEE|CISCO|HUAWEI|
HAMMER|extend}}
Global
config
This sets trunk packet
type of instance
Result: This sets trunk packet type of instance.
36. To display stp related configuration.
i. To display stp information, use command show stp in
global configuration mode. This is shown in
Table 182.
TABLE 182 SHOW STP COMMAND
Format Mode Function
show stp Global
config
This displays stp
information
Result: This displays stp information.
ii. To display stp instance information, use
command show stp instance [<0-15>] in global
configuration mode. This is shown in
Table 183.
TABLE 183 SHOW STP INSTANCE COMMAND
Format Mode Function
show stp instance [<0-
15>]
Global
config
This displays stp
instance information
Result: This displays stp instance information.
iii. To display stp port information, use command
show stp port [<portlist>] in global configuration mode.
This is shown in
Table 184.
TABLE 184 SHOW STP PORT COMMAND
Format Mode Function
show stp port [<portlist>] Global
config
This displays stp port
information
Result: This displays stp port information.
iv. To display stp trunk information, use command
show stp trunk <trunklist> in global configuration mode.
This is shown in
Table 185.