Zte ZXR10 2920 - Table 390 Set Alarm Command

Chapter 9 Network Management
Confidential and Proprietary Information of ZTE CORPORATION 237
<1-65535> {rising|falling}|owner <string>|status
{valid|underCreation|createRequest| invalid}} in
SNMP config mode. This is shown in
Table 390.
TABLE 390 SET ALARM COMMAND
Format Mode Function
set alarm <1-65535> {interval <1-
65535>|variable <mib-
oid>|sampletype
{absolute|delta}|startup
{rising|falling|both}|threshold <1-
65535> eventindex <1-65535>
{rising|falling}|owner
<string>|status
{valid|underCreation|createRequest|
invalid}}
SNMP
config
These
create/configure
instances of the
alarm group
Result: These create/configure instances of the alarm group.
Command line configuration of alarm group is to configure
alarmTable in the alarm group. The configuration involves:
f alarmInterval.
f alarmVariable: It indicates the object identifier of a
specific variable to be sampled in the local mib, for
example, for sampling the etherHistoryBroadcastPkts,
the variable value shall be 1. 3. 6. 1. 2. 1. 16. 2.
2. 1. 7. x. x, where, “x. x” indicates the sampling
bucket of an instance of the history group.
f alarmSampleType: The “absolute” indicates the absolute
value, and “delta” indicates the relative value.
f alarmStartupAlarm: It can be “risingAlarm(1)”,
“fallingAlarm(2)” and “risingOrFallingAlarm(3)”, which
indicate that, after the instance becomes effective, the
first sampling starts when the rising sampling value
exceeds the threshold, the falling sampling value is lower
than the threshold or both cases occur simultaneously.
f alarmRisingThreshold.
f alarmFallingThreshold.
f alarmRisingEventIndex.
f alarmFallingEventIndex.
f alarmOwner.
f alarmStatus: It can be “valid”, “underCreation”,
“createRequest” and “invalid”. When it is set to
“invalid”, the alarm instance is deleted.
Alarm variable can be configured only when object to be
sampled specified by alarm variable can sample data.
Status can be set to “valid” only when alarm variable is
configured successfully.