Zte ZXR10 2920 - Table 48 Protocol-Vlan Command; Table 49 Port Jumbo Command; Table 50 Create Port Command; Table 51 Port Description Command

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
72 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 48 PROTOCOL-VLAN COMMAND
Format Mode Function
set port
<portname>
description
<string>
Global
config
This sets port description
Result: This sets port description.
17. To set port’s macaddress, use command set port
<portlist> macaddress {on <1-16> | off } in global
configuration mode. This is shown in
Table 49.
TABLE 49 PORT JUMBO COMMAND
Format Mode Function
set port
<portlist>
macaddress
{on <1-16> |
off }
Global
config
This sets port’s macaddress
Result: This sets port’s macaddress.
18. To set the ACL info, use command set port <portlist> acl
<acl-number> {enable | disable} in global configuration
mode. This is shown in
Table 50.
TABLE 50 CREATE PORT COMMAND
Format Mode Function
set port
<portlist> acl
<acl-number>
{enable |
disable}
Global
config
This sets the ACL info
Result: This sets the ACL info.
19. To set port vlanjump, use command set port
<portlist>vlanjump {enable [defaultauthvlan<1-4094>]
| disable }in global configuration mode. This is shown in
Table 51.
TABLE 51 PORT DESCRIPTION COMMAND
Format Mode
Function
set port
<portlist>vlanjump
{enable
[defaultauthvlan<1-
4094>] | disable
Global
config
This sets port vlanjump
Result: This sets port vlanjump.