Zte ZXR10 2920 - Table 438 Set Loop Detect Port Vlan Command; Table 439 Set Loop Detect Trunk Command; Table 440 Set Loop Detect Trunk Vlan Command

Chapter 10 Maintenance
Confidential and Proprietary Information of ZTE CORPORATION 295
2. To enable/disable loop test function of specified port in
specified vlan, use command set loopdetect port
<portlist> vlan <1-4094> {enable|disable} in global
config mode. This is shown in
TABLE 438 SET LOOP DETECT PORT VLAN COMMAND
Format Mode Function
set loopdetect
port <portlist>
vlan <1-4094>
{enable|disable}
global config This enable/disable
loop test function of
specified port in
specified vlan
Result: This enable/disable loop test function of specified
port in specified vlan.
Note: By default, port loop test function is disabled.
3. To enable/disable loop test function of a trunk, use
command set loopdetect trunk <trunklist>
{enable|disable} in global config mode. This is shown in
Table 439.
TABLE 439 SET LOOP DETECT TRUNK COMMAND
Format Mode Function
set loopdetect
trunk <trunklist>
{enable|disable}
global config This enable/disable
loop test function of
a trunk
Result: This enable/disable loop test function of a trunk.
Note: By default, loop test function of a trunk is disabled.
4. To enable/disable loop test function of a trunk on a
designated vlan, use command set loopdetect trunk
<trunklist> vlan <1-4094> {enable|disable} in global
config mode. This is shown in
TABLE 440 SET LOOP DETECT TRUNK VLAN COMMAND
Format Mode Function
set loopdetect
trunk <trunklist>
vlan <1-4094>
{enable|disable}
global config This enable/disable
loop test function of
a trunk on a vlan
Result: This enable/disable loop test function of a trunk on a
vlan.
Note: By default, loop test function of a trunk is disabled.
5. To enable/disable loop test protection function of specified
port, use command
Table 441.