Chapter 9 Network Management
Confidential and Proprietary Information of ZTE CORPORATION 251
3. To add a member based on temporary device ID obtained
from collected topology information, use command set
group add device <idlist> in group config mode. This is
shown in
Table 412.
TABLE 412 SET GROUP ADD DEVICE COMMAND
Format Mode Function
set group add
device <idlist>
group config This adds a
member based on
temporary device
ID obtained from
collected topology
information
Result: This adds a member based on temporary device ID
obtained from collected topology information.
4. To delete a device with specified member ID from cluster,
use command set group delete member <idlist> in group
config mode. This is shown in
Table 413.
TABLE 413 SET GROUP DELETE MEMBER COMMAND
Format Mode Function
set group delete
member <idlist>
group config This deleted a
device with
specified member
ID from cluster
Result: This deletes a device with specified member ID from
cluster.
E
ND OF STEPS
Cluster member has been add/delet.
When a device is added to cluster but member ID is not
specified, system automatically allocates a unique ID to the
member.
Configuring Cluster Parameters
This topic describes the configuration of cluster parameters.
For the configuration of cluster parameters, perform the
following steps.
1. To set cluster name, use command set group name
<name> in group config mode. This is shown in
Table 414.
TABLE 414 SET GROUP NAME COMMAND
Format Mode Function
set group name group config This sets cluster
Result
Note:
Purpose
Steps
To Next Page
Loading...
