Zte ZXR10 2920 - Set Qos; Table 202 Set Qos Queue Schedule Command; Table 203 Set Qos Policer Parameters Command; Table 204 Set Qos Policer Parameters Command

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
134 Confidential and Proprietary Information of ZTE CORPORATION
Format Mode Function
<0-63> traffic-
class <0-3>
DSCP to QoS profile
Result: This sets the mapping of the DSCP to QoS profile.
3. To configure global queue schedule profile, use
command set qos queue-schedule queue0-weight <1-
32> queue1-weight <1-32> queue2-weight <1-32>
queue3-weight <1-32> in global configuration mode.
This is shown in
Table 202.
TABLE 202 SET QOS QUEUE SCHEDULE COMMAND
Format Mode Function
set qos queue-
schedule queue0-
weight <1-32>
queue1-weight
<1-32> queue2-
weight <1-32>
queue3-weight
<1-32>
global config This configures
global queue
schedule profile
Result: This configures global queue schedule profile.
4. To configure the parameters of the flux monitor, use
command set qos policer counter-mode {L1 | L2 | L3} in
global configuration mode. This is shown in
Table 203.
TABLE 203 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set qos policer
counter-mode {L1 |
L2 | L3}
global config
This configures the
parameters of flux
monitor
Result: This configures the parameters of flux monitor.
Note:set counter mode of the qos policer. By default, it
works in L2 mode.
5. To configure the promise speed parameters of the flux
monitor, use command set qos policer <0-255>
parameters <1-25165824>in global configuration mode.
This is shown in
Table 203.
TABLE 204 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set qos policer
counter-mode {L1 |
L2 | L3}
global config
This configures the
promise speed of
flux monitor
Result: This configures the promise speed of flux monitor.