Zte ZXR10 2920 - Configuring Global ACL; Table 194 Config ACL Hybrid Command; Table 195 Rule Command

Chapter 7 Service Configuration
Confidential and Proprietary Information of ZTE CORPORATION 129
1. To enter into Hybrid ACL, use command config acl
hybrid number <acl-number> in global configuration mode.
This is shown in
Table 194
TABLE 194 CONFIG ACL HYBRID COMMAND
Format Mode Function
config acl hybrid
number <acl-
number>
global config This enters into
Hybrid ACL
Result: This enters into Hybrid ACL.
2. To configure the rules of ACL, use command rule <rule-
id> {permit|deny} {< ip-protocol> | ip | tcp | udp|
arp}{<source-ipaddr wildcard>|any} [<source-port
sourceport-mask>]{<destination-ipaddr wildcard>|any}
[<dest-port destport-mask>][dscp] [fragment] [ether-
type <proto-number>] [cos][<source-vlanId>] [<source-
mac wildcard >| any] [<destination-mac wildcard>| any] in
ACL config mode. This is shown in
TABLE 195 RULE COMMAND
Format Mode Function
rule <rule-id>
{permit|deny} {<
ip-protocol> | ip | tcp
| udp|
arp}{<source-ipaddr
wildcard>|any}
[<source-port
sourceport-
mask>]{<destination-
ipaddr wildcard>|any}
[<dest-port destport-
mask>][dscp]
[fragment] [ether-
type <proto-
number>]
[cos][<source-
vlanId>] [<source-
mac wildcard >| any]
[<destination-mac
wildcard>| any]
ACL config
This enters into
ACL rules
Result: This enters into ACL rules.
E
ND OF STEPS
Hybrid ACL has been configured.
Configuring Global ACL
This topic describes the configuration of global ACL.
Result
Purpose