Zte ZXR10 2920 User Manual

Chapter 10 Maintenance
Confidential and Proprietary Information of ZTE CORPORATION 303
Please Press any Key to Start!
Welcome !
ZTE Corporation.
All rights reserved.
login:admin
password:*********
zte>en
password:
zte(cfg)#
Troubleshooting Password
This topic describes how to troubleshoot the enable password.
To troubleshoot the enable password, perform the following
step.
1. To trouble shoot to enable password is same as described in
Troubleshooting the User Name/Password.
E
ND OF STEPS
Password is enabled.
Troubleshooting a Device
Connection
This topic describes how to troubleshoot the interconnection of
two devices so that they can be connected to two switch ports in
a same VLAN.
To troubleshoot the interconnection of two devices in the same
VLAN, meet the following requirements.
 PVID of the port is configured incorrectly.
 Port is disabled.
 VLAN is disabled.
 IP address is not set on the equipment or IP address is not in
same network segment.
To troubleshoot the interconnection of two devices in the same
VLAN, perform the following steps.
1. Modify the PVID of the port to be consistent with the related
VLAN ID.
2. Enable all ports.
Purpose
Steps
Result
Purpo
se
Prerequisites
Steps

Zte ZXR10 2920 Specifications

General

Jumbo Frame	9K Bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Power Supply	AC 100-240V, 50/60Hz
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Category	Switch