188/782
This screen provides a read-only summary of the VPN tunnel. Click Save.
Quick Setup > VPN Setup Wizard > Welcome > Wizard Type > VPN Settings
(Summary)
Now the rule is configured on the ZyWALL/USG. The Phase 1 rule settings appear in
the VPN > IPSec VPN > VPN Gateway screen and the Phase 2 rule settings appear
in the VPN > IPSec VPN > VPN Connection screen. Click Close to exit the wizard.
Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings > Wizard completed
Go to CONFIGURATION > VPN > IPSec VPN > VPN Gateway, click Show Advanced
Settings. Configure Authentication > Local ID Type as IPv4 and set the Content as
To Next Page
Loading...
