Parameters 241
64.26 AL2 20 to 30% Percentage of samples recorded by amplitude logger 2 that
fall between 20 and 30%.
0.00 … 100.00% Amplitude logger 2 samples between 20 and 30%. 100 = 1%
64.27 AL2 30 to 40% Percentage of samples recorded by amplitude logger 2 that
fall between 30 and 40%.
0.00 … 100.00% Amplitude logger 2 samples between 30 and 40%. 100 = 1%
64.28 AL2 40 to 50% Percentage of samples recorded by amplitude logger 2 that
fall between 40 and 50%.
0.00 … 100.00% Amplitude logger 2 samples between 40 and 50%. 100 = 1%
64.29 AL2 50 to 60% Percentage of samples recorded by amplitude logger 2 that
fall between 50 and 60%.
0.00 … 100.00% Amplitude logger 2 samples between 50 and 60%. 100 = 1%
64.30 AL2 60 to 70% Percentage of samples recorded by amplitude logger 2 that
fall between 60 and 70%.
0.00 … 100.00% Amplitude logger 2 samples between 60 and 70%. 100 = 1%
64.31 AL2 70 to 80% Percentage of samples recorded by amplitude logger 2 that
fall between 70 and 80%.
0.00 … 100.00% Amplitude logger 2 samples between 70 and 80%. 100 = 1%
64.32 AL2 80 to 90% Percentage of samples recorded by amplitude logger 2 that
fall between 80 and 90%.
0.00 … 100.00% Amplitude logger 2 samples between 80 and 90%. 100 = 1%
64.33 AL2 over 90% Percentage of samples recorded by amplitude logger 2 that
exceed 90%.
0.00 … 100.00% Amplitude logger 2 samples over 90%. 100 = 1%
75
75 Pump logic
Configuration settings for the pump station.
75.01 Operation mode Selects the pump control mode.
Off Use this setting for a single pump. 0
Trad ctrl Traditional pump control mode.
One pump at a time is controlled by the drive. The remaining
pumps are direct-on-line pumps that are started and stopped
by the drive logic.
1
No. Name/Value Description FbEq
To Next Page
Loading...
