234 Parameters
56.06 Signal3 mode Defines the way the signal selected by parameter 56.03
Signal3 param is displayed on the optional control panel.
Disabled Signal not displayed. Any other signals that are not disabled
are shown together with their respective signal name.
-1
Normal Shows the signal as a numerical value followed by unit. 0
Bar Shows the signal as a horizontal bar. 1
Drive name Shows the drive name. (The drive name can be set using the
DriveStudio PC tool.)
2
Drive type Shows the drive type. 3
56.07 Local ref unit Defines how speed reference is entered and displayed by
the control panel and DriveStudio PC tool. Also determines
the unit of signal 02.34 Panel ref.
Note: This parameter also applies to external control when
speed reference is given from the control panel.
rpm Speed reference is displayed and entered in rpm. 0
Percent Speed reference is displayed and entered in percent. The
scaling is as follows:
1
58
58 Embedded Modbus
Configuration parameters for the embedded fieldbus (EFB)
interface.
See also chapter Control through the embedded fieldbus
interface on page 329.
58.01 Protocol ena sel Enables/disables the embedded fieldbus communication
protocol.
Note: When the embedded fieldbus interface is enabled, the
drive-to-drive link operation (parameter group 76) is
automatically disabled.
Disabled Disabled. 0
Modbus RTU Modbus RTU protocol enabled. 1
58.03 Node address Defines the node address.
0…247 Node address. 1 = 1
58.04 Baud rate Selects the baud rate of the RS-485 link.
4800 4.8 kbit/s. 0
9600 9.6 kbit/s. 1
19200 19.2 kbit/s. 2
38400 38.4 kbit/s. 3
57600 57.6 kbit/s. 4
76800 76.8 kbit/s. 5
No. Name/Value Description FbEq
20.01 Maximum speed
0%
Control panel
reference
Speed (rpm)
100%
-100% 20.02 Minimum speed
0
To Next Page
Loading...
