110 Parameters
Summary of parameter groups
Group Contents Page
01 Actual values Basic signals for monitoring of the drive. 112
02 I/O values Input and output states and values; control and status words. 113
03 Control values Speed and torque control values. 123
04 Appl values Process and counter values. 123
05 Pump values Pump station actual values. 124
06 Drive status Drive status words. 126
08 Alarms & faults Alarm and fault information. 131
09 System info Drive type, program revision and option slot occupation information. 134
10 Start/stop/dir Start/stop/direction, run enable and emergency stop source selections;
start inhibit and start interlock configuration.
135
11 Start/stop mode Start and stop modes; magnetization settings; DC hold configuration. 140
12 Operating mode Selection of external control location and EXT2 operating mode. 141
13 Analogue inputs Analog input signal processing. 142
14 Digital I/O Configuration of digital input/outputs, relay outputs, the frequency input,
and the frequency output.
148
15 Analogue outputs Selection and processing of actual signals to be indicated through the
analog outputs.
158
16 System Local lock and parameter lock settings; parameter restore; user
parameter set load/save; parameter change log reset; parameter list
settings; unit of power selection; application macro display.
164
19 Speed calculation Speed scaling, feedback and supervision settings. 167
20 Limits Drive operation limits. 170
21 Speed ref Speed reference source selection and processing. 172
22 Speed ref ramp Speed reference and emergency stop (OFF3) ramp settings. 173
23 Speed ctrl Speed controller settings. 176
25 Critical speed Configuration of critical speeds (or ranges of speed) that are avoided
due to, for example, mechanical resonance problems.
184
26 Constant speeds Constant speed selection and values. 185
27 Process PID Configuration of process PID control. 187
28 Procact sel Process actual value (feedback) settings. 191
29 Setpoint sel Process setpoint (reference) settings. 193
30 Fault functions Configuration of behavior of the drive upon various fault situations. 195
31 Motor therm prot Motor temperature measurement and thermal protection settings. 197
32 Automatic reset Configuration of conditions for automatic fault resets. 202
33 Supervision Configuration of signal supervision. 202
34 User load curve Configuration of user load curve. 205
35 Process variable Selection and modification of process variables for display as
parameters 04.06 … 04.08.
207
36 Timed functions
Configuration of timers. 214
38 Flux ref Flux reference and U/f curve settings. 218
40 Motor control Motor control settings such as performance/noise optimization, slip gain,
voltage reserve and IR compensation.
219
To Next Page
Loading...
