ABB ACQ810 - Control Interfaces; Programmable Analog Inputs; Programmable Analog Outputs; Programmable Digital Inputs and Outputs

Program features 65
Control interfaces
 Programmable analog inputs
The drive has two programmable analog inputs. Each of the inputs can be
independently set as a voltage (0/2…10 V or -10…10 V) or current (0/4…20 mA)
input by a jumper on the JCU Control Unit. Each input can be filtered, inverted and
scaled. The number of analog inputs can be increased by using FIO-xx I/O
extensions.
See also Pressure sensor connection examples on page 108.
Settings
Parameter group 13 Analogue inputs (page 142).
Diagnostics
Parameters 02.04…02.13 (page 113).
 Programmable analog outputs
The drive has two programmable current-type analog outputs. Each output can be
filtered, inverted and scaled. The number of analog outputs can be increased by
using FIO-xx I/O extensions.
Settings
Parameter group 15 Analogue outputs (page 158).
Diagnostics
Parameters 02.16…02.19 (page 114).
 Programmable digital inputs and outputs
The drive has five digital inputs, a digital start interlock input, and two digital
input/outputs.
One digital input (DI5) doubles as a PTC thermistor input. See section Thermal motor
protection on page 78.
One of the digital input/outputs can be used as a frequency input, the other as a
frequency output.
The number of digital input/outputs can be increased by using FIO-xx I/O extensions.
Settings
Parameter group 14 Digital I/O (page 148).