282 Parameters
Internal 24V The drive control unit is powered from the drive power unit it
is mounted on. This is the default setting.
0
External 24V The drive control unit is powered from an external power
supply.
1
95.03 Temp inu ambient Defines the maximum ambient temperature. This
temperature is used to calculate the estimated drive
temperature. If the measured drive temperature exceeds the
estimated value, an alarm (COOLALARM) or fault
(COOLING) is generated.
0…55 °C Drive ambient temperature. 1 = 1 °C
97
97 User motor par
Motor values supplied by the user that are used in the motor
model.
97.01 Use given params Activates the motor model parameters 97.02…97.12.
Notes:
Parameter value is automatically set to zero when ID run is
selected by parameter 99.13 IDrun mode. The values of
parameters 97.02…97.12 are updated according to the
motor characteristics identified during the ID run.
This parameter cannot be changed while the drive is
running.
NoUserPars Parameters 97.02…97.12 inactive. 0
UserMotPars The values of parameters 97.02…97.12 are used in the
motor model.
1
UserPosOffs Reserved. 2
AllUserPars Reserved. 3
97.02 Rs user Defines the stator resistance R
S
of the motor model.
0.00000 … 0.50000
p.u.
Stator resistance in per unit. 100000 =
1p.u.
97.03 Rr user Defines the rotor resistance R
R
of the motor model.
0.00000 … 0.50000
p.u.
Rotor resistance in per unit. 100000 =
1p.u.
97.04 Lm user Defines the main inductance L
M
of the motor model.
0.00000 …
10.00000 p.u.
Main inductance in per unit. 100000 =
1p.u.
97.05 SigmaL user Defines the leakage inductance
σL
S
.
0.00000 … 1.00000
p.u.
Leakage inductance in per unit. 100000 =
1p.u.
97.09 Rs user SI Defines the stator resistance R
S
of the motor model.
0.00000 …
100.00000 ohm
Stator resistance. 100000 =
1ohm
97.10 Rr user SI Defines the rotor resistance R
R
of the motor model.
0.00000 …
100.00000 ohm
Rotor resistance. 100000 =
1ohm
97.11 Lm user SI Defines the main inductance L
M
of the motor model.
0.00 …100000.00
mH
Main inductance. 100 = 1 mH
97.12 SigL user SI Defines the leakage inductance
σL
S
.
No. Name/Value Description FbEq
To Next Page
Loading...
