ABB ACQ810 - Timed Functions

214 Parameters
35.19 Proc var3 unit Specifies the unit for parameter 04.08 Process var3 (process
variable 3).
0…98 See parameter 35.05 Proc var1 unit.1 = 1
35.20 Proc var3 max Maximum value for process variable 3. See diagram at
parameter 35.16 Signal3 max.
-32768…32768 Maximum value for process variable 3. 1 = 1
35.21 Proc var3 min Minimum value for process variable 3. See diagram at
parameter 35.16 Signal3 max.
-32768…32768 Minimum value for process variable 3. 1 = 1
36
36 Timed functions
Configuration of timers.
See also section Timers on page 74.
36.01 Timers enable Enable/disable control for timers. Whenever the source
selected by this parameter is off, timers are disabled; when
the source is on, timers are enabled.
DI1 Digital input DI1 (as indicated by 02.01 DI status, bit 0). 1073742337
DI2 Digital input DI2 (as indicated by 02.01 DI status, bit 1). 1073807873
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
Const Bit pointer setting (see Terms and abbreviations on page
109).
-
Pointer
36.02 Timers mode Specifies whether the time periods defined by parameters
36.03 Start time1 … 36.18 Stop day4 are valid daily or
weekly.
36.03 Start time1 Defines the start time for time period 1.
00:00:00 …
24:00:00
Start time for time period 1. 1 = 1 s
(24:00:00 =
86400)
36.04 Stop time1 Defines the stop time for time period 1.
00:00:00 …
24:00:00
Stop time for time period 1. 1 = 1 s
(24:00:00 =
86400)
36.05 Start day1 Defines the week day on which time period 1 begins.
No. Name/Value Description FbEq
Bit Function
0
Timer1 mode
0 = Daily
1 = Weekly
1
Timer2 mode
0 = Daily
1 = Weekly
2
Timer3 mode
0 = Daily
1 = Weekly
3
Timer4 mode
0 = Daily
1 = Weekly