280 Parameters
82.11 Supervis delay Delay for signal triggering of the cleaning sequence. See
parameter 82.09 Supervis source.
0…600 s Cleaning sequence triggering delay. 1 = 1 s
82.12 Trig pointer Cleaning sequence trigger input selection. See parameter
82.01 Pump clean trig, bit 6.
Not used No input selected. 0
DI1 Digital input DI1 (as indicated by 02.01 DI status, bit 0). 1073742337
DI2 Digital input DI2 (as indicated by 02.01 DI status, bit 1). 1073807873
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
Const Bit pointer setting (see Terms and abbreviations on page
109).
-
Pointer
82.13 Clean max ctrl Defines the action taken if the maximum number of cleaning
sequences (82.14 Clean max number) is exceeded within
the time set by parameter 82.15 Clean max period. Forced
cleanings are disregarded.
Not sel No action taken. 0
Alarm The drive generates an alarm, MAX CLEANINGS.1
Fault The drive trips on fault MAX CLEANINGS.2
82.14 Clean max number Defines the maximum number of cleaning sequences within
the time set by parameter 82.15 Clean max period.
0…30 Maximum number of cleaning sequences. 1 = 1
82.15 Clean max period Defines the time (ending now) within which cleaning
sequences are counted.
0.00 … 35791394.11
h
Time within which cleaning sequences are counted. 100 = 1 h
82.16 Clean step acc Defines the acceleration time from 0 rpm to the step
frequency (parameters 82.02 Fwd step and 82.03 Rev step).
0…32767 s Step acceleration time. 1 = 1 s
82.17 Clean step dec Defines the deceleration time from the step frequency
(parameters 82.02 Fwd step and 82.03 Rev step) to 0 rpm.
0…32767 s Step deceleration time. 1 = 1 s
83
83 Energy monitoring
Energy consumption monitoring settings.
See also section Energy consumption monitoring on page
81.
83.01 Energy mon mode Enables/disables, and selects the mode of, consumed
energy monitoring.
Not used Energy monitoring not in use. 0
Limits The current energy monitoring period is compared to the
consumption limit set by parameter 83.03 kWh limit.
1
Previous The current energy monitoring period (parameter 05.20 kWh
current read) is compared to the previous period (05.21 kWh
prev read).
2
No. Name/Value Description FbEq
To Next Page
Loading...
