ACS2000 User manual 2UEA001270 Rev. F 10-29 (32)
Chapter 10 - Troubleshooting and maintenance
• Open the securing hinges of
the tray tool to firmly attach the
tray tool to the drive frame.
(This prevents any movement
of the tray tool while pulling out
the phase module.)
Make sure to open the hinges to prevent dropping the
phase module and the tray tool.
8 Frames 2, 3 - Insert the module
tray into the cabinet along the lower
sides of the phase module.
• Slide the phase module tray
tool in, until it makes contact
with the metal flange on both
sides of the NP frame and the
spring clip engages.
9 Hold the phase module by the
handle and pull it out slowly until it
is flush with the leading edge of the
tray.
Note: Verify that the module tray
tool is firmly in place during this
step.
To Next Page
Loading...
