AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B 13
Safety information
Requirements for safe operation
In order to operate in a safe and efficient manner the device should be
properly handled and stored, correctly installed and set-up, properly oper-
ated and correctly maintained.
Personnel qualifications
Only persons familiar with the installation, set-up, operation and mainte-
nance of comparable devices and certified as being capable of such work
should work on the device.
Special information and precautions
These include
• The content of this operating instruction,
• The safety information affixed to the device,
• The applicable safety precautions for installing and operating electrical
devices,
• Safety precautions for working with gases, acids, condensates, etc.
National regulations
The regulations, standards and guidelines cited in this operating instruction
are applicable in the Federal Republic of Germany. The applicable national
regulations should be followed when the device is used in other countries.
Device safety and safe operation
The device is designed and tested in accordance with the relevant safety
standards and has been shipped ready for safe operation. To maintain this
condition and to assure safe operation, read and follow the safety infor-
mation in this operating instruction. Failure to do so can put persons at risk
and can lead to device damage as well as damage to other systems and
devices.
Protective lead connection
The protective lead (ground) should be attached to the protective lead con-
nector before any other connection is made.
Risks of a disconnected protective lead
The device can be hazardous if the protective lead is interrupted inside or
outside the device or if the protective lead is disconnected.
Risks involved in opening the covers
Current-bearing components can be exposed when the covers or parts are
removed, even if this can be done without tools. Current can be present at
some connection points.
Risks involved in working with an open device
All work on a device that is open and connected to power should only be
performed by trained personnel who are familiar with the risks involved.
To Next Page
Loading...
