ABB AO2000-Fidas24 - Pump Activation, Pump Output Adjustment

AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B 269
Pump activation, pump output adjustment
Switching the pump on and off
The pump installed in the internal pneumatic module and external pumps
connected to appropriately configured digital outputs can be activated and
deactivated manually, for instance in emergency situations.
The emergency shutdown cannot be overridden by the automatic calibration.
Setting the pump output
The output of the pump installed in the internal gas module can be adjusted
manually only when the pump is in operation.
If there is a flow sensor in the pneumatic module, its reading is shown when
adjusting the pump output.
Menu path
MENU → Maintenance/Test → Analyzer spec. adjustm. → Pump