ABB AO2000-Fidas24 - Removing a System Module

AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B 191
Removing a system module
Sequence when removing system modules
When removing system modules from the gas analyzer always proceed ac-
cording to the following sequence:
1 Remove the system module in the software (see below for instructions).
2 Dismount the system module from the gas analyzer.
Removing an installed system module without a replacement
1 Select the Set Up System Modules menu item.
The list of the system modules existing in the system is displayed.
2 Select the system module to be removed (and not replaced).
3 Press the DELETE softkey.
This will irretrievably remove the system module’s parameter settings
and function block configuration!
4 In the list the deleted system module’s status will change to Deleted.
5 Save the configuration change by pressing ENTER or discard it by
pressing Back.