AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B 79
Gas analyzer installation
ATTENTION
Depending on its design, the gas analyzer weighs from 18 to 25 kg!
Two persons are needed for installation!
The installation location (e.g. bay, 19-inch rack, wall) must be capable of
supporting the gas analyzer’s weight.
The 19-inch housing must be supported with rails in the bay or rack.
Neither the 19-inch nor the wall-mount housings use hinges to secure the
housing cover! The cover can drop when opened.
Requisite material
19-inch housing
• 4 oval head screws (Recommendation: M6; this depends on the cabi-
net/rack system).
• 1 pair of mounting rails (execution depends on the cabinet/rack system).
Wall-mount housing
• 4 screws M8 or M10.
Installation
Install the system housing in the cabinet/rack or using the selected mount-
ing accessories. Refer to the dimensional diagrams (see page 76).
To Next Page
Loading...
