ABB CRB 15000 - Page 1010

NoteAction
xx2000002134
For robots with RobotWare earlier than 7.10
Place the cover at mounting position and recon-
nect the brake release connector DR.X8 to the
drive board.
2
Cable tiesFor robots with RobotWare earlier than 7.103
xx2000002133
Secure the brake release cable with a cable tie.
Valid for CRB 15000-5/0.95Refit the cover with the four screws.4
Hex socket head cap screw: M3x8
12.9 Lafre 2C2B/FC6.9 (4 pcs)
Tightening torque: 0.2 Nm
Valid for CRB 15000-10/1.52 and
CRB 15000-12/1.27
Hex socket head cap screw: M3x12
12.9 Lafre 2C2B/FC6.9 (4 pcs)
Tightening torque: 1.4 Nm
xx2000002132
Continues on next page
1010 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.6.7 Replacing the axis-5 joint unit and the axis-5 to axis-6 transition cabling
Continued