ABB CRB 15000 - Safety During Maintenance and Repair

1.6 Safety during maintenance and repair
1.6.1 Safety during maintenance and repair
General
Corrective maintenance must only be carried out by personnel trained on the robot.
Maintenance or repair must be done with all electrical, pneumatic, and hydraulic
power switched off, that is, no remaining hazards.
Make sure that there are no loose screws, turnings, or other unexpected parts
remaining after work on the robot has been performed.
When the work is completed, verify that the safety functions are working as
intended.
Hot surfaces
Surfaces can be hot after running the robot, and touching these may result in burns.
Allow the surfaces to cool down before maintenance or repair.
Allergic reaction
Elimination/ActionDescriptionWarning
Make sure that protective gear
like goggles and gloves are al-
ways worn.
When working with lubricants
there is a risk of an allergic reac-
tion.
Allergic reaction
Gearbox lubricants (oil or grease)
When handling oil, grease, or other chemical substances the safety information of
the respective manufacturer must be observed.
Note
Take special care when handling hot lubricants.
Risk of exceeding design life
Regular inspections, maintenance, and exchange of worn components are essential
to ensure the safe operation of this robot. Follow the instructions in section
Maintenance on page 183.
Related information
See also the safety information related to installation and operation.
Product manual - CRB 15000 33
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
1 Safety
1.6.1 Safety during maintenance and repair