ABB CRB 15000 - Testing the Flexpendant Connection

3.5.3 Testing the FlexPendant connection
Introduction
The ASI Setting application can be used to verify to which robot the FlexPendant
is connected.
1 In the ASI Setting application, select Light indicator.
2 Toggle the Enabled switch to turn on or off the light ring on the robot.
3 Inspect on which robot the light ring is affected.
Note
This technique should also be used to verify a Robot Control Mate connection
before starting work.
110 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.3 Testing the FlexPendant connection